pjnewberry

One monitor two computers

4 posts in this topic

I'm using a switch to switch my monitor between my two systems. Since both my computers are using the same monitor will that effect Synergy from installing properly

Share this post


Link to post
Share on other sites

Hi pjnewberry! That won't affect the installation and the setup of Synergy.

Share this post


Link to post
Share on other sites

OK..that's very good news. After I read your response I was preparing to ask back "then why doesn't it switch back and forth". Well, you can guess what happened..I went to the client and it was working. It had not been working but after you answered the question, it started working...your magical. Actually I think I was just being too impatient. Once I switched back to the client and just sat there a minute trying to figure out what to write back, it started working properly.

Thank you for your time...much appreciated.

PJ

Share this post


Link to post
Share on other sites
51 minutes ago, pjnewberry said:

OK..that's very good news. After I read your response I was preparing to ask back "then why doesn't it switch back and forth". Well, you can guess what happened..I went to the client and it was working. It had not been working but after you answered the question, it started working...your magical. Actually I think I was just being too impatient. Once I switched back to the client and just sat there a minute trying to figure out what to write back, it started working properly.

Thank you for your time...much appreciated.

PJ

You're most welcome PJ. Have a geat day! :-)

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.